Home Automation Domotica Forum Europe, Bwired Forum

I addes some wait for sending commands.. Now I got new problem, I just changed the antenna and connecting the device to usb and from start I got red light. Only reboot the linux helped for that.

I found that sometimes if I modprobe -r and modprobe back, it will come back alive, but not always. Sometimes I just need to unplug the cable. I cannot understand why is the device going to boot mode if it gets lots of activity? If I send repeatly some codes and it will receive at the same time, it ...

Is there some way to reset the device ..? I send maybe some dozens packets and maybe the rfxtrx device is receiving same time.. and then the red light comes up and the device is not responding after that. I can only unplug the cable or reboot the machine. Is there some solution to remove the linux m...

I am bit confused about Danfoss TWA-L device, .. if I install it.. does it sends/receive information wireless and the wiring is just for the motor or will the data go with wires? And where can I found those TWA-L (088H3133) for low price? I asked from local store and prices very too high for me. And...

This device rfxtrx433 is so good! Very nice to read and write just from the ttyUSBx.. compared to my old tellstick duo.

Ok, I was googling rfxtrx and sdk and no good results for that.

Thanks for advices!

I am using those Nexa sensors by Tellstick DUO and I get like 15 messages per event/motion in few seconds. I have old firmware, old software (telldus-core / tdadmin) .. old stuff for that's why that I have device under /dev and easy to control by perl scripts.. But I will move to rfxtrx if I find su...

I just bought couple of KD101LA .. was trying to extend my home automation system to smoke detectors. But I was very surpised that I did not collect any codes from those detectors by old telldus core .. My system is still for ubuntu but I will change to debian when 7 is out. So my receiver/transceiv...