Page 1 of 1

My visonic app for iphone

Posted: Sat Aug 06, 2011 11:16 pm
by Phaeton
I just found the 'myvisonic' app in the app store. it doesn't work for me. It gives a page not found error. I think I have an old version of the powerlink. I have an internal powerlink but i bought it as a powerlink, not a powerlink2.

Does this app work for you guys? And if so, what is you hard- and software version of your powerlink?

As an addition: my hw version is #123, my sw version is # 3.1.11

Re: My visonic app for iphone

Posted: Sat Aug 06, 2011 11:50 pm
by TANE
For this you will need the powerlink 1 or the powerlink 2

For the powerlink 2 you will need hardware version >6
Firmware >5.4

Powerlink 1 is the older version and will work on the most Powermax alarms.


App looks nice.
there is also a Android version.

re:My visonic app for iphone

Posted: Sun Aug 07, 2011 12:01 am
by Phaeton
As you can see my powerlink hardware states #123. do you mean the powerlink or powermax hardware?
App does look nice indeed :)

Posted: Sun Aug 07, 2011 1:34 am
by Phaeton
Found out that the remote programmer software states that i have a hw-v9_4 version and software is v4.6.06, sw version was looked up in the menu of the alarm. Powerlink module itself works fine if i log in through the network or internet.

I think the app is a mobile site optimized for iphone. Maybe i miss the correct software in the powerlink? I cannot update this myself?