Which Plugin for PMIX35 and Homeseer?

Post by **Francois** » Fri Mar 13, 2009 7:22 pm

Reading through all posts on the PMIX35 its clear there is a plugin available for Homeseer. I tried to find it but did not Succeed. Can somebody point me in the right direction??

Francois
________________________________________________________________________________________________________________________
Homeseer V2, RFXcom receiver, Harrisson Electric Curtains, Touchscreen + homebrew interface. DigiBee+, Velleman Relay board, homebrew optocoupler interface, homebrew Aritech interface, homebrew DigiBee-Homeseer interface.

Post by **drmacchi** » Fri Mar 13, 2009 9:31 pm

Isn't it the same of CTX35? I think so. Other ideas?

Post by **TANE** » Fri Mar 13, 2009 11:26 pm

Yep it's the same as the CTX35
ACT TI103

Post by **Francois** » Sat Mar 14, 2009 8:13 am

Thx.

I have seen that one, but the homeseer site says its RS232 instead of USB. Do I need a third party virtual com driver?

Francois
________________________________________________________________________________________________________________________

Post by **TANE** » Sat Mar 14, 2009 11:51 am

Driver on the CD will install USB <> RS232 convert driver.
In Homeseer just select the new com poort.

Post by **drmacchi** » Sat Mar 14, 2009 12:08 pm

Chack is right. My case is: a SERIAL CTX35 , plugged on a rs232-usb adapter (lack of com port in my notebook). I use a virtual com port created by drivers. when i start HS , i have an error on COM port but it works perfectly anyway. Cheers, Lorenzo

Post by **TANE** » Sat Mar 14, 2009 12:16 pm

@Lorenzo,
I have also the startup error this is because of the short timeout in the ACT TI103 plugin.
Also the PMX35 will show the same error at startup.

Post by **drmacchi** » Sat Mar 14, 2009 1:23 pm

Thanks Chak. I'm also using your txt instructions to open com port in HS .ini file. Isn't there a way to solve this little problem? Lorenzo

Post by **Francois** » Sat Mar 14, 2009 10:16 pm

Same error here, but also no problems while operating.

Running the PMIX35 with the ACT TI103 plugin from the homeseer updater (2.0.0.5) connected using the Belkin USB/Ethernet hub.

Seems to run smoothly, thanks for pointing me in the right (plug-in) direction.

What would be nice is to have a couple of virtual devices that reflect the diagnostics info from the PMIX, something like "Last Voltage", "Noise" and "impedance". This will of course require an expanded plugin, does such a thing exist?

Francois
________________________________________________________________________________________________________________________

Post by **TANE** » Sat Mar 14, 2009 11:04 pm

Yep..that is what I'm also looking for..
I hope one of the developers is interested in building a plugin...