Howto send dim commands with IMX10 to a DAX4
Howto send dim commands with IMX10 to a DAX4
Hello, i installed a IMX10 in combination with a 1-vlaks impulsdrukker (don't know the english words). Now i like to send on-off and dim commands from the IMX10 to a DAX4. I programmed the IMX10 with the option 'Impulsdrukker 1-vlaks (dimmen)'. Futher i made macro's which send on or off commands to the DAX4. All of that works fine. However, i can't figure out how to send dim/feller commands to the DAX4 when you press the impulsdrukker longer dan 1 sec. Please some advise
Howto send dim commands with IMX10 to a DAX4
Did you put them on the same address?
Howto send dim commands with IMX10 to a DAX4
no, is that the trick, putting them on the same address ?
Howto send dim commands with IMX10 to a DAX4
ok, tryed tbat and its working fine, thx for your advise Bastiaan.