in general there is no delay involved when relaying IR codes.
BUT: The IR Code itself has got a certain length. As the IRTrans is not receiving and sending at the the same time it needs to receive the IR Code before it can be sent again. That means there will always be a delay that has got the length of the IR code itself (100-500ms).
You can lower the delay by changing the IR Timeout in the device settings. That is the time the IRTrans waits to see if the IR Code is "over".
Depending on your remote control you can try different values here. The default is 90ms. The value can be set using the IRTrans GUI Client or the Web interface for LAN / WLAN Devices.
Users browsing this forum: No registered users and 0 guests