These sensors are designed for stand-alone mode and produce for 3 to 5 seconds about 50 RF messages. This will disturb the RF signals of other sensors. If you send a command to an RFXCOM transmitter it will wait until the AC sensor has stopped transmitting. The reason for this is that it has no use for the RFXCOM transmitter to start transmitting if another sensor is active because both signals are disturbed due to the RF collision.
Code: Select all
AC sensor transmits RF =================================================
| | 5 seconds later the AC sensor stops transmitting RF
AC sensor received in application
|
Command to the RFXCOM transmitter - wait--------| RFXCOM starts transmitting RF
The preferred motion sensor for lighting control is the X10 MS13.
The X10 MS90 motion sensor can be used for security purpose only.