Home Automation Domotica Forum Europe, Bwired Forum

I have not changed the way it is controlled, but I was definitely able to open the housing. Unless something has changed in the last two years it is just some small screws. I took down the rail, but can’t remember if that was necessary for opening the housing.

Hi Bart,

Any News on the mqtt version?

The http version has been rock solid for me the last few years. I am thinking about migrating from HS to HA and an mqtt version would be easier in switching back and forth between these two systems.

Hi Bart,

That is a pleasant surprise. I would definitely be interested in the mqtt version.

Kind regards,
John

Is there a link to LabView 2009 or is it a paid application? I cant see to find a compatible version which will run the Windows App you have created. Or is it a paid application that cant be shared? I cant quite tell as the website is completely down at the moment. Thanks in advance. You need to in...

Thanks Bart,
Added functionality is great!
John

Hi Morten, This is not about on or off (as for sensors). This controls the virtual device that reflects your panel state. Just create some status values for this virtual device (1 = disarmed, 2 = armed home etc) and then the http call for disarmed is the JSON call you know (value =1), and so on. Reg...

Hi Daniel, I do not think this will help you much, I have not built my own serial cable, I already had the remote programming software kit with cable and RS232 connector. I am using the Visonic driver software by Bart Bakels domoticaforum.eu/viewtopic.php?f=68& ... mp;t=11129 , which can communi...

You should be able to use the auxiliary port on the gsm module (if you mean the one at the bottom). That is where I put it and it works with the remote programming software as well as the Powerlink alternatives. Nothing else required.

John

Stef,
Tot nu toe geen foutmeldingen meer met deze versie.

Dank,
John

in addition did you change any zones, as Mario mentioned? No, no changes to zones. I cannot fully exclude the possibility that I had (briefly) running two instances (perhaps doubleclicking too fast), but I do not recall saving settings at that time (but cannot exclude the possibility that I did, in...

Hi Bart,

I lost that part of the configuration (http calls) again, no apparent reason.

Kind regards,
John

Mario, Probably better to await Bart's answer, but for both your info: I had the same issue with 1.07. Uninstalling and reinstalling helped. Make a copy of settings.ini However, all my user http events were deleted after putting the backup of setting.ini in the settings folder. I ended up copying an...

If entering installer mode does not prevent the alarm, can't you just temporarily remove the siren from the config?

(backup current config first)

Thanks for the new version Bart, it's running great. Regarding the Labview error I mentioned earlier: I cannot reproduce it under normal circumstances (neither in 1.0.3 nor in 1.0.4). When thinking about it further: the errors always occurred when the computer was restarted, so quite some processes ...