Home Automation Domotica Forum Europe, Bwired Forum

TerrorSource wrote: how did you manage to solve this?
Got the same issue.

> soft_reset_halt
requesting target halt and executing a soft reset
Failed to halt CPU after 1 sec
Halt timed out, wake up GDB.

I haven't solved this.
Have ordered a usb to jtag convertor cable.
Still have to figure out how to use this.

When I google "Error: JTAG scan chain interrogation failed: all zeroes" I find a lot of wiring problems. I checked that multiple times, so I made a Fritzing on my wiring. The little black block in the middle is de JTAG-interface on the Toon/Quby. I use a Raspberry Pi 2 model B v 1.1, runn...

When I google "Error: JTAG scan chain interrogation failed: all zeroes" I find a lot of wiring problems. I checked that multiple times, so I made a Fritzing on my wiring. The little black block in the middle is de JTAG-interface on the Toon/Quby. I use a Raspberry Pi 2 model B v 1.1, runni...

With sudo i managed to set up the telnet-connection. The soft_reset_halt and reset halt are not capable of stopping the processor. Could you help me again? pi@raspberrypi:~ $ sudo openocd -f rpi.cfg -f ed20.cfg Open On-Chip Debugger 0.10.0+dev-00166-g0e4fbfb (2017-07-01-14:41) Licensed under GNU GPL...

Should have tried that...
How could I forget.
Will retry tomorrow. Thank you for the fast reply!

Hello, I have a toon with a 16-XXX serial number, so I have to use root using JTAG. I cannot get into telnet because the openocd-command ends with "Permission denied" I use a ftdi-usb-connector for the serial monitor. For JTAG I use a direct connection from a RaspberryPi 2b GPIO to the JTA...