Home Automation Domotica Forum Europe, Bwired Forum

Will try, thanks for the tip!

I do, ~470ohm per LED.

Is there a command to list all current alternative messages used with AA/DA (and while we're on the subject, for the UI/KI and SR/KR command pairs?) When I tried the UI command I was surprised to see when reading through the messages tab that there were default alternatives already set, and only by ...

Nah, it started WDT-ing on me again, sometimes even a couple of times per day. So I pulled the OTGW from my house and brought it to work. My coworker then noticed that I had soldered the LEDs very poorly on the header and redid the connections for me, so I'm now hoping that there was a spurious shor...

AA=28 can help, but there must be an ID that is unknown before the 'alternative' message can be inserted. Monitor the messages for a while and look for one that is obviously unneeded, with my Remeha Calenta/Remeha iSense setup there are no unknown messages over the OpenTherm so I had to cancel the '...

Replying to myself first: no the problem did not go away by integrating the two programs. Hey @sincze, do you send PM=xx commands to the OTGW? I've been prodding at this again, replaced the PM=28 every so many seconds by UI=29 and AA=28 (no solar storage temperature needed here, but I do want the re...

Has anybody configured sending of mails when a WDT reset occurs? I have (so I get a nice email every time it resets), but I've also set up warning mails for too high and too low a pressure and temperature. So, besides the WDT reset mails, I see mails like these: The room temperature has dropped belo...

I'm having the exact same problem (WDT reset immediately after startup) after a year of no problems, so I'm wondering whether we're looking at a power supply/hardware problem.