Home Automation Domotica Forum Europe, Bwired Forum

Hi, there I managed to get the hardware OTGW running and I am able to connect to it via the browser and entering the TCP/IP address of the OTGW. My configuration is as follows: the OTGW is connected to a separate LAN port (switch), my desktop (Ubuntu) to another LAN port (same switch), both are part...

Hi hvxl, I connected the otwg to my laptop (UTP cable), changed the properties of IPv4 of my laptop (adapter settings) I changed the IP address of the laptop to 192.168.0.1, the subnet as usual and the default gateway my modem router address. Then I connected via 192.168.0.7 in the browser and indee...

Hi hvxl,

Thanks I am not sure how to do that (configure an IP address in the 192.168.0.0/24 subnet on my PC), but I will try to figure that out tomorrow.

Regards Kees

Hi hvxl, Thanks for the reply I agree, not really a OTGW problem, but one of the prerequisites to get it done. Your answer kept me thinking my IP addresses are in the pool limited to 192.168. 1 .XXX (typical dutch I think), so it will not connect anyway. Is there a way to change the TCP/IP address o...

Hi there, I am new to this forum and I just bought an opentherm gateway plus USR TCP232, I have soldered everything and connected the board to the network. The configuration has a 24 VDC power supply. After power up one led on the board is blinking green, on the UTP connector one led is green steady...