Home Automation Domotica Forum Europe, Bwired Forum

Hi, Not sure where to post, but I thought I'd start here. Using OTGW I collect various info among which the Boiler setpoint temperatures and CH water temperatures. I'm using a weather compensation control setup (weersafhankelijk) and I can see the Setpoint temperatures nicely following (opposite tem...

Hi, In my otmonitor log I find the following messages: 17:12:50.759813 T001B0000 Read-Data Outside temperature (MsgID=27): 0.00 17:12:50.901071 B401BFF1A Read-Ack Outside temperature (MsgID=27): -0.90 17:12:50.928116 A401BFF34 Read-Ack Outside temperature (MsgID=27): -0.80 I have read that the B mes...

hvxl wrote: ↑Wed Dec 14, 2022 11:00 pm OTmonitor currently will send a PS=0 after a PS=1 report when collecting a capability log. Maybe I should make it an option to do that always.

I second that. Would make reading things a lot easier and be very usefull.

Interesting indeed. Yes, the boundaries were still 50 to 0 before I changed the setting on the boiler. After I set the boiler to 80, I didnt check the string of values itself (PS=1), but I did send a PS=0 command straight after which then resulted in updated boundary values "80 0" in the &...

I managed to increase SH to above 50. It turned out its not (just) setting the code CP000 to 80 on the Remeha Tzerra Ace, but rather (or also?) the max temp value before you even go into the menu of the boiler. See below: In case anyone has the same issue in the future, I’ve added the part where it’...

hi. Thanks. I tried what you said. On the boiler I made sure I set CP000 to 80. (I also set CP010 back to 50 as I realised this is a 'fail-safe' value, and I want to keep it) Then I pressed the reset button on the OTGW board (resent version bought from Nodo-shop) for about 3 seconds. All leds switch...

thanks for the info. I do remember the installer asked me about the max temp. I have floor heating downstairs, radiator heating upstairs. I checked and indeed it was setting CP000 on the Remeha Tzerra Ace that was set to 50 degrees. Just to have the flexibility I now increased it back to 80, but ......

Hi all, Installed my OTGW and have it integrated in Domoticz. All seems working fine as far as I can see. Two questions though: 1] I'm trying to set a maximum boiler water temp. I'm using the command SH for this in OTMonitor (Max CH water setpoint) Although I set SH to 35 and I get this confirmed in...

Clear. Thanks. I do still have my original OT thermostat, so Ill check the OTGW on how to connect it.

This thread is a bit old already, but I have a question which is related. I've just had a Remeha zTerra Ace installed. An eTwist thermostat is connected directly, without any separate gateway. The "Ace" version supports this. Yesterday I ordered my OTGW. Question: Would I need an extra gat...