Home Automation Domotica Forum Europe, Bwired Forum

The LM12 needs a minimum load current to operate. The unit does not use the life and neutral directly for it's own electronics.

Han Alink

Hi, When I'm leaving my house, I have to enter a code to a (outside) keypad, to set the alarm (Marmitek SC9000). Seting the alarm is detected by my home control system an takes care of other tasks. When I'm comming home vice versa. I don't consider this way of "leaving" or "comming ho...

Hi,
I have a DIY "poesdouche" (cat shower). And I can tell you it works. After some time you don't have to power the unit anymore. The cat recognizes the unit and will not come into it's neighbourhood anymore.

Han Alink

Hello Peter
I tried using extended commands with the LW11 and you are completely right. The type3 commands are working!
Thanks

Han Alink

Hi Peter,
Thanks; I mixed up the numbers. I looked up the first one in your list (LW11; which I own myself), which is an old Marmitek unit (not supporting extended code). But the other units (ACT, Eaton) of cause have extended facilities.

Han Alink

Hi Peter,

Was not aware of that. In the documentation I have, this is not documented. Can you give me a pointer to the right document (LW12)?

Han Alink

Hi Peter,
I think you are mistaken. Those units do not support extended code (or they must have been changed recently)!

Han Alink

Hi,
Might be the same kind of problem as http://www.domoticaforum.eu/topic.asp?TOPIC_ID=402


Han Alink

I think ACT has some units.

Han Alink

<blockquote id="quote"><font size="1" face="Verdana, Arial, Helvetica" id="quote">quote:<hr height="1" noshade id="quote">I disconnected the switch from the AD10 and the volt meter do not measure anything then <hr height="1" nosha...

Hi,
Your switches do not have leds or other indicators to show their state?
If not, can you disconnect the switch from the AD10, and measure again?


Han Alink

<blockquote id="quote"><font size="1" face="Verdana, Arial, Helvetica" id="quote">quote:<hr height="1" noshade id="quote">- Another, simpler, issue I have is that is I keep only A7 on (all the other AD10 set to 0) the module work fine from ...

The behaviour you describe has nothing to do with X10.
Is your house using 1 phase?

Han Alink

Must be a wiring problem!

Han Alink

Hi, I'm wondering how to continue. As far as I can see now, it is possible to build a unit with 220Volt input and outputs for 3 groups of LEDS. Each group can contain up to 3 LEDs in series with a maximum current of about 350mA. The groups can be seperately controlled by X10 commands. Each group als...