Home Automation Domotica Forum Europe, Bwired Forum

Loxx electronisch slot met mini controller. ...

wie heeft er interesse ?

Henk

Ik heb er ook nog twee

Henk

This hardware is based on Zwave and it is a fairly closed system / no new developments and no support
It is developed by the same company as the Home Control Box and Toon but no relationship at all.

So good luck ..... Henk

I'm right now developing irrigation controllers to be used for the garden, flowerbeds (bloembakken) and green houses. The controllers are based on the micro processor Arduino combined with all kind of sensors. If required those irrigation controllers can be integrated with Zwave and operational toge...

mijn email ... homenica at hotmail.com

Henk

Nogmaals de X10 koop van de eeuw wie biedt ? De SAIX en DAIX modules zijn getest 5x SAIX 7x DAIX10 3x DAIX12 1x SAIX12 5x MS13 3x AIX12 2x AIX 2x IMX10 2x PIOX15 3x GIX 1x LW12 6x DIX2 1x PUX - x10 tester 3x SW10G jalouzie 3x IRIX35 x10 infrarood ontvanger 1x X10-IR-afstandsbediening 1x HR10 2x SFX4...

X10 Modules [gebruikt, prototypes, nieuw en kleine kans op defect] DIX2 6x LW12 1x DAIX10 7x SAIX12 3x AIX 3x AIX2 1x AIX12 3x DAIX12 3x SAX1 2x SAIX 3x GIX 2x HR10 1x X10 Modules PIOX15 2x IMX10 2x SW10G 1x ZAX 1x MS13 5x IRIX35 3x CIX 1x PUX 1x Sperfilters 2x Special modules HCB 1x (Home Control B...

Yes it will be enough if you limit your RGB led strip to a 10cm segment with 3 leds this segment can be connected directly to the output pins and you are able to experiment with PWM techniques. The output of Arduino pins is limited in power you need to add transistors to boost the output power. Chec...

Here is a simple sensor .... it will make a contact closure when the water reached a certein level....

http://www.conrad.nl/ce/nl/product/6227 ... n?ref=list

Henk

The universal binary module has only two inputs - the specifications is a little misleading and common misinterpret ... the two outputs are reflecting directly the inputs and are not programmable .... so you need a Fibaro 2x1,5Kwh to control either the switches or the solenoid. The benefit of this m...

One way is to connect the two buttons to a Fibaro double relay module by soldering wires on the printed circuit board and connecting them to the potential free contacts of the Fibaro module. Some programming is required to set the cat flap in night mode / vet mode. /reset mode like the catflap is ma...

I was searching for a similar piece of hardware but it is not yet on the market . Current offers of Zwave I/O are expensive like the binary sensor of Fibaro for input or the double relay output module for output ... I'm considering using an Arduino as an I/O frontend plenty of I/O including analog a...

Indeed Fibaro is limited in timer functions but it is possible even without using LUA but you need 4 scenes .... at least three scenes are a kind of system scenes and are handy for other applications scenes One scene to specify weekdays so use a time function at 00:00 with vinked weekdays and make v...

It is a known problem ...the firmware was changed and not yet supported in Homeseer ... Fibaro HC2 has a similar support problem with this device.... check the forums

Henk

.. mag ik ook mee op dondderdag ....

1x voor Henk