Home Automation Domotica Forum Europe, Bwired Forum

Beste Schelte, Thanks for the elaborate explanation. I downloaded the latest version and it works fine now. Sending the commands manualy does not "yet" give the correct result. When I send this commands AA=18, UI=16, UI=24, two other MsgIDs should replace it if I understand correctly. That...

I tried "capability log" again today, and now it finisched well
See attachment.

I used this commands:
UI=16
UI=24
PM=26 (this one you can also see in the log file I uploaded)

See here a long log file, hope it helps...

Installed the latest release ( version still shows 6.4 )
Now it stays at "Checking message ID 5", whole night.
No error message.

I will create a log and sent it to you, by your website. I treid the capability log but get always this error (toepassingsfout): can't set "gui(returntemp)": can't use non-numeric string as operand of "-" can't use non-numeric string as operand of "-" while executing &q...

I haven't used commands yet, when I send PM=26 nothing happens (except that I see it in the log)
See screenshot.
I also tried the UI command but no result.

Hi Schelte, Thanks for this great OTGW firmware. I'm using this OTGW together with HS4, it works good. A lot of info and I can control my thermostat :) Only a few devices in HS4 are only updating when I start "Compability log" in the Opentherm monitor. (The HS4 devices where also created w...

• Supports setpoint override, by HS4 plugin from Bernold OTGW plugin (Resolution 0.5°C)

• Nodo Shop OT gateway works fine

To see the temperature device, the temp sensor must be connected when you include the module To the z-wave network.
(In my case)

Beste Bastiaan, zou heel mooi zijn als het werkt.
Welke associaties heb je bij de qubino 2-relay?
Groet Paul

Heb mijn fibaro FGS-222 V2-2 nu ook goed werkend door Association group 3 te verwijderen
Nu de qubino nog...

I have to Fibaro FGS-222 one V2-1 and one V2-2

Now they work both ok.
I had to remove "Assoiciation Group 3" to let it show the status ok in the web interface when controled local

I hope it helps for you to

Ga ik meteen doen
Al komt er op bugzilla weinig respons van HomeSeer

Helaas met de laatste update van de z-wave plug-in nog steeds geen verbetering.
Het vreemde is dat de Fibaro FGS-222 V2-1 wel goed werkt en V2-2 weer niet goed

Hopelijk komt er snel een oplossing.