Home Automation Domotica Forum Europe, Bwired Forum

What is the format of the Set Mode command send to the RFXtrx433? Did you save a Set Mode with Rubicson enabled? This will be restored if the RFXtrx433 is reset. how do I check the set mode command? Rubicson was not enabled, I always reset the rfxtrx after each mode change, so I disabled rubicson, ...

I have been using rfxmgr, seems the TH10 - Rubicson/IW008T/TX95 must belong to a neighbour, but I find it odd that it does not show up when Rubicson is enabled, but it does show up when Hideki/UPM is enabled, surely this must be wrong? not much of an issue for me as I do not use either Hideki or Rub...

even if I disable rubicson, I still get rubicson readings: 0A520A18A90200D00E0269 Packettype = TEMP_HUM subtype = TH10 - Rubicson/IW008T/TX95 channel 2 Sequence nbr = 24 ID = 43266 Temperature = 20,8 °C Humidity = 14 Status = Dry Signal level = 6 Battery = OK strange thing is that I only have TFA 30...

I upgraded my rfxtrx433 to firmware 433_64 and now I have issues with the humidity-reading from some of the sensors, looking at the rfxcom debug in DomotiGA it reads unknown sub type for packet type 52:a, I have attached a screenshot strangely enough two of my sensors work as intended, and the other...