Home Automation Domotica Forum Europe, Bwired Forum

Hi, Have a look here: http://www.domoticaforum.eu/viewtopic.php?f=68&t=6581&start=45#p63022 It describes the pinout for a Powermax+. I'm pretty sure Powermax+'s with earlier software versions did not have Powerlink features, but could connect to this serial port with the Visonic Remote Progr...

Hi, The type of Powermax you are trying to connect to is not clear from your post. Just so you know, a Powermax+ has a different pinout for the serial connector. If you do have a Powermax+, have a look at: http://www.domoticaforum.eu/viewtopic.php?f=68&t=6581&start=45#p63022 It describes in ...

The Powermax+ CPU (M3062LFGPFP) is supplied with 5V. Verified that on my older panel that is retired now. I have no reason to believe that the electrical characteristics have changed, so I have to assume that the CPU is actually out-of-spec tolerant of the 3V3 TX level from my FTDI board, or that bo...

Some success! Last night my new Powermax+ panel arrived. My old panel has old firmware and I was told by Visonic that it could not be updated. It has no powerlink features. So I bought a new Quickfit kit as the additional sensors were welcome and I really would like to get the alarm connected to our...

Hi, I'm entering this discussion with a keen interest in this protocol. I'd like to get a PowerMax+ interfaced with my 'MeterkastPC' that is in close proximity. Two things prevent me from actively taking part in the discussion: 1) no RS232 interface (yet). The Visonic RS232 adapter for the PowerMax+...