Home Automation Domotica Forum Europe, Bwired Forum

Since a while i am trying to get the wifi module with the opentherm gateway working. I seems to lose the connection after about 10 seconds Does somebody have it in running condition. Pls advice Huib Hi Huib Sorry i could not reply earlier, i was not looking at this post since it was working for me....

Hi Guru

i have the same setup as you have, same CV, same thermostat and same FW.
i am not using arduino but a domotics system. my connection to the domotica is using the serial to network converter TPlink.

It is running for weeks with no problems.

Hi

you are at the correct website for ordering it.
I think there is a problem because the assembled kit may be out of stock, it indicates back order.

If i were you i would contact the owner via de contact page at that site

The problem seems fixed now. I upgraded the firmware to the latest rev, not sure if this solved it, it was probably the power off / power on that solved the issue

It is stable now. Thank you very much for the support, really appreciated!

Hello Arjan

i followed the instructions and indeed it works now! Thanks for that

However, after some 10 seconds the connection drops ( i see OT monitor color changes to RED)
This happens everytime....

Any idea what this could be?

Thanks Arjan

I will try this when i am back at home, right now i am abroad for 2 days.
i am not sure if i have sufficient linux knowledge to get this done, but i will give it a try

Hi All I have purchased the opentherm gateway and this seems to work ok. When I connect it directly to my pc, using the USB hub, then I see the communication using the OTMonitor. I can also send commands. But now I want to use the LAN/WIFI Tplink module that came with this shipment. I connected the ...