Home Automation Domotica Forum Europe, Bwired Forum

What do you mean? Can you make a schematic for my?
It's just easier to understand for me

I just made a schematic. Is it true if I connect them?


Bigger pic:
http://oi60.tinypic.com/jagufo.jpg

I have this error on my pc with windows xp

I have the same md5 hash: DF48A1AAABADEC687D9A1821FD63EB7D SHA265: 79B8516F9150CFBCBCFDEA6471E79451B3BFFE1F2C8211EDF69290E17D794CE7
File is 5,988,508 Bytes.

File is still not working... Site problem?

Gpio pin is only for outside temperate sensor? Wich type can i connect? For leds, I've already read it. Now all I have how do I connecten him? Connect one side of the LED? And the other with a resistor to ground? What resistor should I use? How do I connect the LED? Is there a diagram of how this wi...

Do you have als md5 of sha hash? Than can i check my file or it is incorrect.

4.0b3 monitor tool.
Gives error by execute:
Error in startup script

I run Windows XP with RS232 connector

I have some questions: - How should the indicators (LEDs) are connected to the LED pin? What resistor do I need and where VCC (ground) I can connect him best. - How the RESET must be connected? - What the GPIO can be used? Of course, all just looked on the site and forum but did not come out. Hence ...

The problem was that a resistor(R1) was not connected properly.
He now works perfectly, I just have a lot of error messages 1.
If I managed to flash firmware 4.0b1 I not have them.

But this firmware does not "OK" when you send a command correctly. Why not? And what has changed!

I checked the Gateway with this list: http://otgw.tclcode.com/debugging.html and then Opentherm interfaces. There are all good values​​, but I have a problem. Do this test: With X1 and X2 still attached, measure the voltage between pin 18 and pin 5. This should be among the 1.25V (essentially 0V). N...

Remeha Quinta 30 C also has such a connector and you can also read by the software.
Now I wonder, how do I get hold of his rope.
The order number is 58,900, but however, I find it too expensive.

As some already know I want to hang between my boiler thermostat and a Gateway so I can see the boiler thermostat to the communication. Just a sketch, so I have a Remeha Quinta 30C. It is connected as follows: http://i39.tinypic.com/2a798ol.jpg Now I have this box connected between the boiler and th...

How an RS232 connecten to OTGW?
I have an RS232 connector but now wants to know what I have to pin solder my RS232 port. Now I know that pin1 is the red wire.

Solved my problem was that all of the RS232 connectors were not connected. So here I soldered it again.

I have the same problem....
Serial port good connect
Firmware upgrade: "Please manualy reset the OTG"
Long time later, this message: Could not switch gateway to self-programming mode