Home Automation Domotica Forum Europe, Bwired Forum

According to the equipment matrix, the TF30 never asks for a setpoint override (MsgID 9). Starting to learn more and more. Did not realise the thermostat was leading, not the boiler. So that means that the gateway mode is useless for this thermostat and monitor mode is what I should use (monitor is...

hvxl wrote:You keep mentioning what kind of boiler you have, but whether it's possible to override the temperature setting depends on the thermostat. Which one do you use?

Appologies, thought the boiler was leading... I am using the Bosch TF30 as thermostat.

Verry hot this morning in my house... The communication stalled from my thermostat (Error 01) and the right temperature was not sent to the boiler so it kept on heating. Changing from gateway to monitor restored the communication and put the boiler on ease. (Perhaps a future failsave option in OTG?)...

Using Bosch HRC 30 I have many Error 01 (about once a sec) with 3.4 in GW mode. Just upgrade the OTG to 4.0b3. After the upgrade the Diagmostic window only showed a Txxxxx message and underneath Error 01. Over and over again, nothing else so all communication failed. Then I checked the option Tools ...

After 3 weeks running (can see the boiler temp, flame status, DHW, not able to set anything yet - using VeraLite) I installed the Diagnostic firmware. Used the bit test #2 where the thermostat quite often fails with the only last byte < 900 (but close), the boiler interface #3 is al lot of red, lots...

I'm using the Bosch TF30 and HRC 30 with OTG. Unfortunately the OTG gives a lot of Error 01 @ VR=3 already whith the initial testing (http://otgw.tclcode.com/debugging.html#slave). Setting the value VR=2 fixed the problem however after a while the communication was stopped completely. So perhaps the...