Home Automation Domotica Forum Europe, Bwired Forum

Yes, but its a rea; pain having to dial in wait for x rings hang up and dial in again. Also not very conveinet if you only have one land line.

I recently installed a Web Link Interface to connect my PowerMax Plus to the internet to send status reports and also faciliate reomte access of the PowerMax. I was very disappointed to discover that there are no options for remote administration or configuration of the PowerMax which is a real pain...

All, Still no luck with getting this working on any of the suggested PIn outs thus far. I recently purchased some custom RJ45 to DB 9 connectots that allow you to wire any combination of pin outs from the RJ45 female to the DB9 female. these came in a pack of 5 and I have wasted two alreay (once you...

Thanks, I will make up a cable at the weekend and give it a try. I will let you know who it goes.

Yes, you are correct RJ 45 is 10 pin not 8. my mistake

Thanks for the reply. I am probabaly ok on the DB9 end but am less certain on the RJ 45 powermax end on how I connect the 8 pins from the RJ45 cable (i.e. which is tx / rx ground etc RS 232) to the rJ 11 end (i.e. probabal same as CM11). Just though if someone had one of these cables they could veri...

Does anyone have the cable pin out for the interface cable that is used to connect the Visonic RJ 45 connector to a standard DB9 serial interface ? I alreay have the PowerMax interface which came with the Web Server for remote viewing. I also have an adapter for the serial port on my PC that has an ...