Home Automation Domotica Forum Europe, Bwired Forum

Thanks, but looking at the internal diagram that I can see in the aliexpress link, they are intended for switching loads mains (or 24V) connected. I am looking for two dry and separate output relays which is not what I can see in the diagram. I don't know if it is correct or not, but if I have to r...

You could have a look at https://www.aliexpress.com/store/produc ... 57420.html

Ik heb je een mail gestuurd.

Ik hoop dat iemand nog ergens een fase koppelaar heeft liggen voor X10?

Link?

Have a look at this: https://intronics.nl/nl/products/audiov ... -matrixen/

you need to make sure the OS timezone and time is set correctly, so when running on a PI go into raspi-config and set the timezone correct and make sure NTP is set correctly.

I think the problem is at the side of the switch itself, the input wires of that switch need to be swapped.

Turn the plug in the kaku switch around., or turn the KAKU switch around so that the 2 connector pin's are swapped. The reason for this is that you have a small Earth leak that will keep the light flawly emitting light, as the unswitched wire is the one connected to the phase wire. The Kaku only swi...

After the removal of the cookies this was resolved.

Is there also an issue with the read status of messages?
I normally look at the new posts list but now the last 3 days messages are all in there.

I like to use Filemaker for database engine, it is a real what you see is what you get db with extnted scripting and full relational setup.
You can create portals based on the relation and filtered based on anything you want...

Just import your first excel sheet to begin with and build from there.

the 4 port version IPIO-4R4I-M has No/NC contacts and the 8 port version IPIO-8R8I-M has 2 NO/NC contacts.

On the Arduino, do you see the MAC address on a label? When you have the MAC address you can look at the router list of IP's, where it 99% of the time also shows the MAC address. you can also use a product like this https://www.softperfect.com/products/networkscanner/ to scan the network before and ...

Using 3528 strip with 150 leds per meter would be more then enough light, what I was planning for the same project is a Aluminum L (15 or 20 x 10mm) strip long edge used to put the LED strip and holes for mountingto the underside of the steps with the 10mm side to cover the direct light. I have done...