LMM21 icw. Jung 2-vlaks impulsdrukker?

Forum about Xanura, Eaton Holec and Marmitek and other brand X10 and A10 devices.

LMM21 icw. Jung 2-vlaks impulsdrukker?

Postby rovinge » Thu Jan 17, 2013 10:08 pm

I appreciate your help for the following.

I want to control a Marmitek LMM21 using a Jung Impulsdrukker (type531, with 1-polig maakcontact).

How do I need to connect the black/yellow/red wires from the micromodule to the Jung switch?

I have tried every possible combination connecting the wires to the switch, but with no success. I can get the light turn on/off, but I cannot dim or get it brighter.

Roel
Attachments
Jung Impulsdrukker.JPG
Jung Impulsdrukker.JPG (15.85 KiB) Viewed 3357 times
LMM21-2[1].gif
LMM21-2[1].gif (34.49 KiB) Viewed 3357 times
rovinge
Member
Member
 
Posts: 53
Joined: October 2011
Location: The Netherlands

Re: LMM21 icw. Jung 2-vlaks impulsdrukker?

Postby Peterpc » Thu Jan 17, 2013 11:18 pm

If you want to dim the light, keep the switch pressed for a few seconds.
Peter
http://www.pcgsm.nl/
User avatar
Peterpc
Member
Member
 
Posts: 214
Joined: September 2007
Location: Netherlands

Re: LMM21 icw. Jung 2-vlaks impulsdrukker?

Postby rovinge » Fri Jan 18, 2013 1:01 pm

I have got it working

On/off and dim/bright does work, but not in a way I want to have it working.

Only the top half my switch controls this all, the bottom half of the swith does nothing. By keep pressing the top half of the switch, the light cycles through dim and bright.

What I want is
- the top half of the witch turns the lamp on (single touch) and/or brightens the lamp (keep pressed)
- the bottom half of the witch turns the lamp off (single touch) and/or dims the lamp (keep pressed)

So your feedback is still appreciated.

Roel
rovinge
Member
Member
 
Posts: 53
Joined: October 2011
Location: The Netherlands

Re: LMM21 icw. Jung 2-vlaks impulsdrukker?

Postby Peterpc » Sat Jan 19, 2013 10:53 am

That is only possible with a lwm1p micro module.
Peter
http://www.pcgsm.nl/
User avatar
Peterpc
Member
Member
 
Posts: 214
Joined: September 2007
Location: Netherlands

Re: LMM21 icw. Jung 2-vlaks impulsdrukker?

Postby rovinge » Wed Jan 23, 2013 9:44 am

I have now replaced it by a DAIX12.

Thanks for all the replies.

Roel
rovinge
Member
Member
 
Posts: 53
Joined: October 2011
Location: The Netherlands


Return to X10, A10 Xanura Marmitek Forum

Who is online

Users browsing this forum: No registered users and 1 guest