Marmitek sensors ms13 doesn't connect to control unit SC9000

Forum about Xanura, Eaton Holec and Marmitek and other brand X10 and A10 devices.

Marmitek sensors ms13 doesn't connect to control unit SC9000

Postby Frankge973 » Sat Dec 28, 2013 11:17 am

I bought a second hand control alarm unit Sc9000 plus PIR four sensors, two ms13 and two ms90. Ms13 sensors doesn't register in control unit when I set it up using install area of menu. One ms90 is working perfectly, one is working but only in repetitive detection mode, even if I change the selector on the rear.
In your opinion, why they don't register ?
Thanks
Frankge973
Starting Member
Starting Member
 
Posts: 5
Joined: December 2013

Re: Marmitek sensors ms13 doesn't connect to control unit SC9000

Postby mbliek » Sat Dec 28, 2013 6:26 pm

The ms13 is not an supported motion sensor for the sc9000. Only the ms90
User avatar
mbliek
Starting Member
Starting Member
 
Posts: 35
Joined: June 2013

Re: Marmitek sensors ms13 doesn't connect to control unit SC9000

Postby Frankge973 » Sat Dec 28, 2013 7:52 pm

And do you think is possible to use also sensors of other brands? Or I'm obliged only to use ms90?
Frankge973
Starting Member
Starting Member
 
Posts: 5
Joined: December 2013

Re: Marmitek sensors ms13 doesn't connect to control unit SC9000

Postby mbliek » Sat Dec 28, 2013 9:53 pm

The ms90 is also available from other brands. But it's the same.

But only the ms90 will work
User avatar
mbliek
Starting Member
Starting Member
 
Posts: 35
Joined: June 2013

Re: Marmitek sensors ms13 doesn't connect to control unit SC9000

Postby Frankge973 » Sun Dec 29, 2013 12:37 am

And which cheaper brand and model can I buy?
Frankge973
Starting Member
Starting Member
 
Posts: 5
Joined: December 2013


Return to X10, A10 Xanura Marmitek Forum

Who is online

Users browsing this forum: No registered users and 1 guest