Boosting PMIX35 interface

Forum about Xanura, Eaton Holec and Marmitek and other brand X10 and A10 devices.

Boosting PMIX35 interface

Postby MindBender » Sat Aug 23, 2014 9:03 am

Has anybody successfully modified their PMIX35 interface to output a higher level of X10 signal?

I have had 2 meters of wire sticking out of my wall for a year now, with plans to connect a screen motor. Yesterday I have installed a cable duct to hide the wires and that alone is enough to cut off the whole rear end of my house. I haven't even hooked anything up to the cable!

This is a real inconvenience, because now the shutters in front of my office windows no longer automatically open and close anymore. And installing the duct isn't something I can easily undo...

I recall somebody here once posted about an X10 blaster a guy in the US was working on, but I cannot find that anymore.
MindBender
Advanced Member
Advanced Member
 
Posts: 637
Joined: April 2006
Location: Netherlands

Re: Boosting PMIX35 interface

Postby Bastiaan » Sat Aug 23, 2014 10:21 am

I am using my PMIX on a 3 phase system and length over 50 meters without issues. Never misses a beat.
Guess you are looking for something like this: http://www.intellihome.be/nl/x10-prl11- ... erker.html

Just google for X10 repeater
Bastiaan
Senior Member
Senior Member
 
Posts: 1245
Joined: May 2008
Location: Netherlands

Re: Boosting PMIX35 interface

Postby Peterpc » Sat Aug 23, 2014 10:10 pm

. What is the impedance reading on the pmix35?
It should be more then 2 ohm.
Peter
http://www.pcgsm.nl/
User avatar
Peterpc
Member
Member
 
Posts: 213
Joined: September 2007
Location: Netherlands

Re: Boosting PMIX35 interface

Postby hvxl » Sun Aug 24, 2014 12:37 pm

MindBender wrote:I recall somebody here once posted about an X10 blaster a guy in the US was working on, but I cannot find that anymore.

Do you perhaps mean Jeff Volp? His support is excellent, but I never managed to get my XTB-II to even match the success rate of a TW523.
Schelte
hvxl
Senior Member
Senior Member
 
Posts: 1099
Joined: June 2010


Return to X10, A10 Xanura Marmitek Forum

Who is online

Users browsing this forum: No registered users and 1 guest