In the next day's I'm going to replace the IPPower I/O device with the new add-on from RFXCOM.
The I/O module is added to the existing ethernet device from RFXcom.
There is also no need for additional plugin...all can be managed from RFxcom plugin for Homeseer.
I have already installed the hardware and software
all is working fine.
More will follow in the next days
<hr noshade size="1"><font size="1">Enver
http://twitter.com/Chak64%20My%20Domoti ... dware.html<i> My Domotica Hardware Software</i></font id="size1">
RFXCOM I/O
Moderator: b_weijenberg
RFXCOM I/O
Looks good! Same goes for me check my weblog
http://www.bwired.nl/weblog.asp?id=336
<hr noshade size="1"><font size="1">Pieter Knuvers
http://www.bwired.nl <i>Online House in the netherlands. Domotica, Home Automation.</i></font id="size1">
http://www.bwired.nl/weblog.asp?id=336
<hr noshade size="1"><font size="1">Pieter Knuvers
http://www.bwired.nl <i>Online House in the netherlands. Domotica, Home Automation.</i></font id="size1">
RFXCOM I/O
Looks nice, what's the price?
<hr noshade size="1"><font size="1">Robert
http://www.hekkers.net <i>Digit's Online Home.</i></font id="size1">
<hr noshade size="1"><font size="1">Robert
http://www.hekkers.net <i>Digit's Online Home.</i></font id="size1">
- b_weijenberg
- Forum Moderator
- Posts: 1744
- Joined: Sun May 14, 2006 4:32 pm
- Location: Netherlands
RFXCOM I/O
All sold.
RFXCOM I/O
Hello Bert,
Will there be more units available or was this a once-off run?
Will there be more units available or was this a once-off run?
- b_weijenberg
- Forum Moderator
- Posts: 1744
- Joined: Sun May 14, 2006 4:32 pm
- Location: Netherlands
RFXCOM I/O
This was one series and will not come into production, at least not soon.
Re: RFXCOM I/O
It took me a while before I got round to hooking up my RFXio to my controller. There just one thing I cannot get out of the manual: Which ground pin should I use to connect on the RFXCOM when using the RFCOM powered setup? Can I use the GND pin on the matchport?
- b_weijenberg
- Forum Moderator
- Posts: 1744
- Joined: Sun May 14, 2006 4:32 pm
- Location: Netherlands
Re: RFXCOM I/O
The last pin, after CP10, is the GND (ground) pin