Can i distinguish the different types of Visonic wireless devices using Powercode by looking at a specific bit in one of the received bytes ? I see that the demo program does this when running the code in variable length mode, but not in Visonic mode. Why or what bit?
Thanks
Brgds
Kalimaro
Visonic device types
Moderator: b_weijenberg
- b_weijenberg
- Forum Moderator
- Posts: 1744
- Joined: Sun May 14, 2006 4:32 pm
- Location: Netherlands
Visonic device types
The packet layout is fully described in the documentation that is delivered with the receiver.
Visonic device types
I can not see any documentation on the difference between types.
I want to see if it is a motion sensor or a door sensor....
I want to see if it is a motion sensor or a door sensor....
- b_weijenberg
- Forum Moderator
- Posts: 1744
- Joined: Sun May 14, 2006 4:32 pm
- Location: Netherlands
Visonic device types
Read chapter 9
Visonic device types
Not sure what PDF file you are reffering to ?
Visonic device types
You can also check the code of the Receiver program, in that code you can exactly see what is possible with received bytes patterns.
- b_weijenberg
- Forum Moderator
- Posts: 1744
- Joined: Sun May 14, 2006 4:32 pm
- Location: Netherlands
Visonic device types
The RFXCOM Visonic document I'm refering to is not available on the web site but delivered with the receiver.