Need help with setup

Forum about PLCBUS devices & software.

Moderator: Digit

Post Reply
plastic
Starting Member
Starting Member
Posts: 4
Joined: Mon May 18, 2009 1:23 pm
Location: Sweden

Need help with setup

Post by plastic »

Hi!

I have bought some PLCBUS-2263D and a PLCBUS-1141.

PLCBUS-2263D is connected and works localy (black and yellow wires), I have connected Neutral, Live and Lamp.

PLCBUS-1141 is connected to a computer, driver installd and PLCBUS Universal Controller Program.

I have set the com-port to 4 and open the com port = working.

What is the next step, how do I get the 2263D to respond to the Universal Controller Program? (I have tried holding the button on the 2263 down and the blue light starts to blink after release and then sending ON command but cant get it to work.)

Wrong settings?

/plastic
ruvitec
Starting Member
Starting Member
Posts: 1
Joined: Fri Oct 16, 2009 7:49 am
Location: Germany

Need help with setup

Post by ruvitec »

<font face="Verdana">Hi plastic,

there are three possible mistakes.

#1141 and #2263 are not connected to same phase.
You have chosen 3-Phase communication at Universal Controller Program.
If you use #1141 with German plug style, maybe plug is plug-in up-side down (turn 180)

Regards

ruvitec</font id="Verdana">
Post Reply

Return to “PLCBUS Forum”