ip cam event detection via http trigger

Forum about Domotiga Open Source Home Automation for Linux.

Moderator: RDNZL

ip cam event detection via http trigger

Postby artturi » Sun Feb 08, 2015 12:08 pm

Hello,

I've recently bought a zavio f3115 which has pir motion detection with an ability to do various things when the alarm is triggered.

Among those things is the ability to send an http request.

As i just installed domotiga this morning, I've searched a bit on this forum and in the interface but haven't found an evident way to handle that.
Would you know how I could received those requests in domotiga ?

Best regards,

Mikael
artturi
Starting Member
Starting Member
 
Posts: 1
Joined: February 2015

Re: ip cam event detection via http trigger

Postby BreFra » Mon Feb 09, 2015 7:45 pm

Setup the simple webclient (wiki) and use the url to turn "on" an virtual device. Configure this device in DomotiGa to reset itself to "Off" after a few minutes.
BreFra
Starting Member
Starting Member
 
Posts: 21
Joined: January 2010


Return to DomotiGa Forum

Who is online

Users browsing this forum: No registered users and 1 guest