ip cam event detection via http trigger

Forum about Domotiga Open Source Home Automation for Linux.

Moderator: RDNZL

Post Reply
artturi
Starting Member
Starting Member
Posts: 1
Joined: Sun Feb 08, 2015 12:43 pm

ip cam event detection via http trigger

Post by artturi »

Hello,

I've recently bought a zavio f3115 which has pir motion detection with an ability to do various things when the alarm is triggered.

Among those things is the ability to send an http request.

As i just installed domotiga this morning, I've searched a bit on this forum and in the interface but haven't found an evident way to handle that.
Would you know how I could received those requests in domotiga ?

Best regards,

Mikael
BreFra
Starting Member
Starting Member
Posts: 21
Joined: Wed Jan 06, 2010 10:44 pm

Re: ip cam event detection via http trigger

Post by BreFra »

Setup the simple webclient (wiki) and use the url to turn "on" an virtual device. Configure this device in DomotiGa to reset itself to "Off" after a few minutes.
Post Reply

Return to “DomotiGa Forum”