Domotiga Ethernet Z-Wave support

Forum about Domotiga Open Source Home Automation for Linux.

Moderator: RDNZL

Domotiga Ethernet Z-Wave support

Postby raymonvdm » Fri Nov 29, 2013 8:15 pm


I did not find the answer yet but will DomotiGa support ethernet based Z-Wave adapters (or ser2net interfaces?)

Ser2Net setup which is working in Homeseer
Running HS3PRO on PC with Z-Wave / OpenTherm / Plugwise / RFXcom / MQTT / XAP400 / Logitech Media Server and Squeezelite on PI`s
Senior Member
Senior Member
Posts: 1147
Joined: December 2011

Re: Domotiga Ethernet Z-Wave support

Postby RDNZL » Sat Nov 30, 2013 4:59 pm

Currently the OpenZwave code of DomotiGa only supports serial ports, but if you can emulate one you can try to see if it works ok.
I don't know anyone using it yet.
The RaZberry Zwave code in DomotiGa already supports IP based communication, so using a RasberryPi or Cubieboard with RaZberry module as IP controller works.
Regards, Ron.
User avatar
Forum Moderator
Forum Moderator
Posts: 996
Joined: September 2006
Location: Dordrecht, The Netherlands

Return to DomotiGa Forum

Who is online

Users browsing this forum: No registered users and 1 guest