Plugwise stretch help needed

Plugwise Forum about Plugwise devices and the Source software.
Post Reply
Geertjen
Starting Member
Starting Member
Posts: 9
Joined: Wed Oct 26, 2011 2:57 pm

Plugwise stretch help needed

Post by Geertjen »

Hello

I bought a stretch 2.0 via markplaats. This came without a circle+.
I also have a source set. Is it possible to link the circle + of th source set to stretch 2.0?

Is it correct this can be done by opening the stretch 2.0 box en replace the zigbee usb with the source stick?
What steps needs to be done?

Regards
Geert
User avatar
RdP
Advanced Member
Advanced Member
Posts: 989
Joined: Thu May 04, 2006 10:14 am
Location: Netherlands

Re: Plugwise stretch help needed

Post by RdP »

Please contact Plugwise, they can/will help you set up with what you need.
Rien
PietjeNL
Member
Member
Posts: 150
Joined: Sun May 30, 2010 8:47 am

Re: Plugwise stretch help needed

Post by PietjeNL »

Easiest way is to open the Stretch box and put your source stick into it.
:!: Be warned this is not officially supported :!:

Open stretch en remove stick.
Boot stretch and after boot hold 15 seconds the reset button, u will see it turning red around 15 seconds and then release it.
Wait for it to boot again and disconnect the power.
Now put your own stick from source in the stretch and let it boot and do its thing for 15 minutes.
Now u should have all of your modules visible in the stretch.
Post Reply

Return to “Plugwise Forum”