Preset Dim function on HE108 with RFXCOM

Forum about Click On Click Off (KAKU), Home Easy and related hardware.

Preset Dim function on HE108 with RFXCOM

Postby Theendisnye » Fri Jun 29, 2012 7:06 am

I have a couple of areas where my RXCOM signal was not getting reliably to so I am thinking about adding an RF extender. If an HE108 gets two on signals then it will go into dim cycle mode, is the same true if I send a pre-set dim level from RFXCOM and that is then transmitted by potentially twice to the switch. When I try send repeated presets from RFXCOM I do not go into the Dim cycle. Steve
Theendisnye
Starting Member
Starting Member
 
Posts: 5
Joined: May 2012

Re: Preset Dim function on HE108 with RFXCOM

Postby b_weijenberg » Fri Jun 29, 2012 9:25 am

Sending 2 preset dim command will not set the module into a dim cycle.
To avoid problems with the 2 ON commands you can better use a set level 16 instead of an ON command. But this will only operate on a lamp module. An appliance module cannot be controlled using a set dim level command.
User avatar
b_weijenberg
Forum Moderator
Forum Moderator
 
Posts: 1732
Joined: May 2006
Location: Netherlands


Return to Click On Click Off & Home Easy

Who is online

Users browsing this forum: No registered users and 1 guest