Preset Dim function on HE108 with RFXCOM

Forum about Click On Click Off (KAKU), Home Easy and related hardware.
Post Reply
Theendisnye
Starting Member
Starting Member
Posts: 5
Joined: Fri May 18, 2012 10:19 pm

Preset Dim function on HE108 with RFXCOM

Post by Theendisnye »

I have a couple of areas where my RXCOM signal was not getting reliably to so I am thinking about adding an RF extender. If an HE108 gets two on signals then it will go into dim cycle mode, is the same true if I send a pre-set dim level from RFXCOM and that is then transmitted by potentially twice to the switch. When I try send repeated presets from RFXCOM I do not go into the Dim cycle. Steve
User avatar
b_weijenberg
Forum Moderator
Forum Moderator
Posts: 1744
Joined: Sun May 14, 2006 4:32 pm
Location: Netherlands

Re: Preset Dim function on HE108 with RFXCOM

Post by b_weijenberg »

Sending 2 preset dim command will not set the module into a dim cycle.
To avoid problems with the 2 ON commands you can better use a set level 16 instead of an ON command. But this will only operate on a lamp module. An appliance module cannot be controlled using a set dim level command.
Post Reply

Return to “Click On Click Off & Home Easy”