Aeotec, Fibaro and HASSIO

Forum and Topics about Z-Wave devices.

Aeotec, Fibaro and HASSIO

Postby Brainbox72 » Sun Jan 21, 2018 11:35 am

Hello,

So I decided to start experimenting with Home Assistant (HASSIO) and ZWave.
Bought the Aeotec ZW090 Z-Stick Gen 5 EU and two Fibaro Door/Window sensors.
The Aeotec is inserted in a Raspberry Pi3, the OS is HASSIO.
I did some installing and the Stick and sensors are visible. (see attachment) But after that, nothing happens. I get no message when the door is opened (where the sensor is attached to)
What am I doing wrong, or should I configure more?

Regards,

Brainbox
Attachments
Hassio Zwave.jpg
Hassio Zwave.jpg (25.62 KiB) Viewed 871 times
Brainbox72
Starting Member
Starting Member
 
Posts: 1
Joined: January 2018

Re: Aeotec, Fibaro and HASSIO

Postby uAlex73 » Sat Feb 03, 2018 5:04 pm

I assume your Z-Wave devices are battery powered (then they sleep 99% of the time). Open-Zwave only passes on the open/close signals if the device is fully discovered ... So you need to wake-up your devices and afterwards it should work. Yes - it is a b***** if your restart HASS.io, then you need to wake them up again.
DomotiGa / Z-Wave / RFXCom / Visonic PowerMaster
uAlex73
Member
Member
 
Posts: 213
Joined: January 2012


Return to Z-Wave Forum

Who is online

Users browsing this forum: No registered users and 1 guest