Duwi Zwave.ME Roller shutter ZJ ESJ

Forum and Topics about Z-Wave devices.
Post Reply
raymonvdm
Senior Member
Senior Member
Posts: 1153
Joined: Sun Dec 18, 2011 1:23 am

Duwi Zwave.ME Roller shutter ZJ ESJ

Post by raymonvdm »

Last week i installed the Zwave.ME Motor Controller to control my sunscreen and it is working fine :D But when the window`s are open it still goes down :evil: I have found out that the node support a blocking z-wave node for example a door/window contact but i need an additional contact for this.

Code: Select all


Node Id of the blocking device (Parameter Number 6, Parameter Size 1)
Id of the device which commands would be interpreted not as Open/Close, but as block/unblock. Usefull with door opening detector: if the door is open, block the blind not to break shades while they move.
Value	Description
0	Disabled (Default)
1 — 232	Node Id



On which command from blocking node to enable the protection (Parameter Number 7, Parameter Size 1)
Defines which command from blocking device to interpret as closed door and hence, unprotected.
Value	Description
0	on On (Default)
1	on Off

I have connected the screen using the third (right) schema

Image

It is also possible to disconnect the COM connection using an additional relay but how did other people fixed this?
Running HS3PRO on PC with Z-Wave / OpenTherm / Plugwise / RFXcom / MQTT / XAP400 / Logitech Media Server and Squeezelite on PI`s
Post Reply

Return to “Z-Wave Forum”