Co2 Jeenode

All about Arduino, Jeenode and other Clones (hardware & Software)

Moderator: Mdamen

Post Reply
User avatar
esschenk
Member
Member
Posts: 426
Joined: Sun Feb 17, 2008 10:34 pm
Location: Netherlands
Contact:

Co2 Jeenode

Post by esschenk »

Hello,

Here is my Co2 Jeenode device.
I read the Voltage from this device to a Jeenode
And with a couple events i read the status

Optimal Ventilation
Good ventilation
Poor ventilation

http://domotica.famschenk.eu/JeeNode_Co2_Device.html

Ed
spierie
Member
Member
Posts: 68
Joined: Mon Oct 20, 2008 11:48 am
Location: Netherlands
Contact:

Post by spierie »

Looks good Ed!

Where did you get the sensor from?

Rgds,
Michel.
User avatar
esschenk
Member
Member
Posts: 426
Joined: Sun Feb 17, 2008 10:34 pm
Location: Netherlands
Contact:

Re: Co2 Jeenode

Post by esschenk »

Hello,

I have bought them from someone, he never used it
But there also other Co2 device´s with the same controller board.

Ed
phoenixb
Advanced Member
Advanced Member
Posts: 512
Joined: Thu Jul 23, 2009 1:00 pm
Location: Netherlands

Re: Co2 Jeenode

Post by phoenixb »

Good air ventilation system, 476ppm CO2 is a nice value (normal in side a house circa the 350 ppm).
At this moment i also have a small CO2 sensor connect to the Webcontrol PCB, maybe a nice idea to connect it to the Jeenode.

I your sensor a 0-10Vdc signal?
__________________
User avatar
esschenk
Member
Member
Posts: 426
Joined: Sun Feb 17, 2008 10:34 pm
Location: Netherlands
Contact:

Re: Co2 Jeenode

Post by esschenk »

Hallo DJ,

No its from 0-4Volt

So i made a sheet with some value's from 0 -4 Volt to PPM and with some script i display the
The led’s within Homeseer and everything is working fine for some weeks now.

Ed
Post Reply

Return to “Raspberry, Arduino, Cubietruck and other clones Forum”