powermax pro flash

Forum about Visonic products like Powermax Plus and Powermax Pro

Moderators: Rene, Willem4ever

Post Reply
oz2evp
Starting Member
Starting Member
Posts: 3
Joined: Sun Jun 29, 2014 10:11 pm

powermax pro flash

Post by oz2evp »

hi .

does someone know where to get the firmware flash file and software to update / reload flash into the unit ??

I need it as i cannot get access to the pc programmer software ( bad download code ) even after setting back to factory settings.

I have contacted the dealer where i bought it but they cannot / will not help me .
User avatar
Rene
Global Moderator
Global Moderator
Posts: 1689
Joined: Wed Oct 08, 2008 3:54 pm
Location: Netherlands

Re: powermax pro flash

Post by Rene »

You did this?

Remove all power (mains and battery) from the panel.
Remove the panel from its backplate place face down on a cushioned surface.
Identify the two left hand jumper pins marked DEF and fit a jumper across them.
Restore the battery power - this will reset the control panel.
Remove the battery power, and remove the link from the DEF jumper.
Refit the panel and restore the mains and battery power.
Rene.
oz2evp
Starting Member
Starting Member
Posts: 3
Joined: Sun Jun 29, 2014 10:11 pm

Re: powermax pro flash

Post by oz2evp »

Yes . I have just tryed again . still no go .

I have read on some ohter site that the download code should be AAAA . i have tryed this and 1111 , 9999 but none of those works for me .. Im conecting direct to the pins in tcp/ip with a usb to TTL . I have comunication with the unit so i gues it is a wrong code or a need to re-flash
Post Reply

Return to “Visonic Alarm systems”