Hi,
I'm looking for the communication setting (comport vs hypertherminal) and instructionset to communicate with with the Iskra MT372.
Can someone help me with those information?
Thank you!
Robke
Iskra MT372 Communication settings
Re: Iskra MT372 Communication settings
Today i received the volkszaehler probe and i can communicate at 300b.
But i have a problem when i send the following command /?! i only see the meter ID.
Can someone help me with this?
Is it possible that enexis blocked my meter?
But i have a problem when i send the following command /?! i only see the meter ID.
Can someone help me with this?
Is it possible that enexis blocked my meter?
Re: Iskra MT372 Communication settings
Highly unlikely. Enexis are obliged to give you access to your meter, by law.Is it possible that enexis blocked my meter?
300baud is very slow. The P1 companion standard (v2.2 or thereabouts) states the baudrate should be 9600, data/parity/stop: 7E1.
grtz,
marcelr
Re: Iskra MT372 Communication settings
Hello Marcel,
Right now it possible to communicate with the meter but i only get the default meter values.
I want also get the gas and the current usage.
Did someone over here have commands to communicate with this meter?
Thank you!
Right now it possible to communicate with the meter but i only get the default meter values.
I want also get the gas and the current usage.
Did someone over here have commands to communicate with this meter?
Thank you!
Re: Iskra MT372 Communication settings
Hmm ..
The P1 port just spits out whatever the manufacturer has told it to do.
So, if you don't have gas, tough luck, I'm afraid.
grtz,
marcelr
The P1 port just spits out whatever the manufacturer has told it to do.
So, if you don't have gas, tough luck, I'm afraid.
grtz,
marcelr
Re: Iskra MT372 Communication settings
Hi Robke,
Maybe this topic can be of help: viewtopic.php?f=71&t=7489
Regards
Maybe this topic can be of help: viewtopic.php?f=71&t=7489
Regards