Firmware 3.4 upgrade to Firmware 4.2.4

This Forum is about the Opentherm gateway (OTGW) from Schelte

Moderator: hvxl

Post Reply
raymonvdm
Senior Member
Senior Member
Posts: 1153
Joined: Sun Dec 18, 2011 1:23 am

Firmware 3.4 upgrade to Firmware 4.2.4

Post by raymonvdm »

Last week i tried to get my OpenTherm gateway running in HS3 again. But the "new" HS3 script is not working with Firmware 3.4 since some of the commands seem to be missing in Firmware 3.4. So i have upgrade to 4.2.4 and i`m not using the HS3 script yet, as it is not creating the devices in HS3 (other issue)

In the past i have tried a 4.x firmware but my boiler started to live it`s own life. And i think this issue is back :cry: I have set the room thermostat on 10.00 but it looks like the boiler is firing up once in a while. How can i trouble shoot this to see if it actually does. I do not want a high energy bill because of a possible firmware issue or boiler issue. :D
Running HS3PRO on PC with Z-Wave / OpenTherm / Plugwise / RFXcom / MQTT / XAP400 / Logitech Media Server and Squeezelite on PI`s
hvxl
Senior Member
Senior Member
Posts: 1965
Joined: Sat Jun 05, 2010 11:59 am
Contact:

Re: Firmware 3.4 upgrade to Firmware 4.2.4

Post by hvxl »

Look at the flame status and ch mode bits in ID 0. If they are both on, the boiler is heating.
Schelte
Post Reply

Return to “Opentherm Gateway Forum”