Error 03 with Tado opentherm stat
Posted: Fri Dec 02, 2016 6:21 pm
I have finally got around to buying an opentherm thermostat (Tado) which I have connected through the opentherm gateway and initially all was well (I was seeing it sending temperatures and also modulating the boiler too)
But after a short time, I am now seeing a lot of Error 03's.
I tried changing the offset on all settings, but the issue is the same.
I cannot figure out why it was stable initially but then went wrong.
Attached is my log, my boiler is an Atag A325ECX
Any help appreciated
Thanks
Richard
But after a short time, I am now seeing a lot of Error 03's.
I tried changing the offset on all settings, but the issue is the same.
I cannot figure out why it was stable initially but then went wrong.
Attached is my log, my boiler is an Atag A325ECX
Any help appreciated
Thanks
Richard