No DHW preheating after a power failure

This Forum is about the Opentherm gateway (OTG) from Schelte

Moderator: hvxl

No DHW preheating after a power failure

Postby grubciu69 » Wed Feb 06, 2019 9:31 am

I have Vitodens 100 (boiler 230V power supply) and iSense AD 289 (thermostat powered from OTG) and between them is OTG (battery power supply). Everything works well but after the 230V voltage recovery, after a voltage failure when the boiler does not work, the boiler does not heat up the domestic hot water to the set temperature, the rest is working correctly. After disconnecting and reconnecting the thermostat, everything returns to normal. Can this problem be solved by issuing a command in the OpenTherm Monitor application?
grubciu69
Starting Member
Starting Member
 
Posts: 5
Joined: March 2015

Re: No DHW preheating after a power failure

Postby hvxl » Tue Feb 19, 2019 8:49 pm

It is difficult to make suggestions without understanding what causes the behavior you describe. So please provide a log that covers the whole scenario.
Schelte
hvxl
Senior Member
Senior Member
 
Posts: 1195
Joined: June 2010


Return to Opentherm Gateway Forum

Who is online

Users browsing this forum: No registered users and 1 guest