No DHW preheating after a power failure

This Forum is about the Opentherm gateway (OTGW) from Schelte

Moderator: hvxl

Post Reply
grubciu69
Starting Member
Starting Member
Posts: 5
Joined: Fri Mar 27, 2015 4:22 pm

No DHW preheating after a power failure

Post by grubciu69 »

I have Vitodens 100 (boiler 230V power supply) and iSense AD 289 (thermostat powered from OTG) and between them is OTG (battery power supply). Everything works well but after the 230V voltage recovery, after a voltage failure when the boiler does not work, the boiler does not heat up the domestic hot water to the set temperature, the rest is working correctly. After disconnecting and reconnecting the thermostat, everything returns to normal. Can this problem be solved by issuing a command in the OpenTherm Monitor application?
hvxl
Senior Member
Senior Member
Posts: 1965
Joined: Sat Jun 05, 2010 11:59 am
Contact:

Re: No DHW preheating after a power failure

Post by hvxl »

It is difficult to make suggestions without understanding what causes the behavior you describe. So please provide a log that covers the whole scenario.
Schelte
Post Reply

Return to “Opentherm Gateway Forum”