Remeha iSense and C-mix

This Forum is about the Opentherm gateway (OTG) from Schelte

Moderator: hvxl

Remeha iSense and C-mix

Postby thomas_n » Mon Aug 05, 2019 5:13 pm

Hi everyone,

I have a Remeha boiler which also has a C-mix unit which enables it to control 2 zones. This module is controlled by an iSense thermostat.

Now the special thing about this setup is that the iSense thermostat controls both zones over a single OpenTherm line.

Is this supported in any way by the OpenTherm gateway? I have the module set up, but it is not connected to my computer (yet).

Starting Member
Starting Member
Posts: 1
Joined: August 2019

Re: Remeha iSense and C-mix

Postby hvxl » Wed Aug 07, 2019 12:35 pm

I assume you are referring to the use of the message IDs for a second CH circuit (ID8, 23, 31, 37 and some bits in ID0). The OTGW has no commands to manipulate these. But it will report them and pass them on.
Senior Member
Senior Member
Posts: 1333
Joined: June 2010

Return to Opentherm Gateway Forum

Who is online

Users browsing this forum: No registered users and 1 guest