How to save Monitor mode state?

This Forum is about the Opentherm gateway (OTGW) from Schelte

Moderator: hvxl

Post Reply
vamp
Starting Member
Starting Member
Posts: 9
Joined: Tue Dec 08, 2020 10:03 am

How to save Monitor mode state?

Post by vamp »

Hello there,

I would like to use the OTGW with monitor mode. I able to set it with otmonitor, but every restart it chnange back to Gateway mode. How to save the actual mode?
hvxl
Senior Member
Senior Member
Posts: 1965
Joined: Sat Jun 05, 2010 11:59 am
Contact:

Re: How to save Monitor mode state?

Post by hvxl »

There is currently no way to run the OTGW in monitor mode, other than sending it the GW=0 command after each restart.

Recently I made a change to have the DHW mode setting survive a restart. I will look into doing the same for Monitor mode.
Schelte
hvxl
Senior Member
Senior Member
Posts: 1965
Joined: Sat Jun 05, 2010 11:59 am
Contact:

Re: How to save Monitor mode state?

Post by hvxl »

Starting with 4.2.8, the monitor mode setting is saved in EEPROM. Once configured using GW=0, the OTGW will continue to run in monitor mode following a restart.
Schelte
vamp
Starting Member
Starting Member
Posts: 9
Joined: Tue Dec 08, 2020 10:03 am

Re: How to save Monitor mode state?

Post by vamp »

Great, thanks a lot!!
Post Reply

Return to “Opentherm Gateway Forum”