Flashing firmware problem

This Forum is about the Opentherm gateway (OTGW) from Schelte

Moderator: hvxl

Post Reply
Chriskras
Starting Member
Starting Member
Posts: 17
Joined: Thu Nov 14, 2013 12:36 pm

Flashing firmware problem

Post by Chriskras »

This week I got a GatewayOT inside.
This I now flash the correct firmware. I want it gateway.hex flash but I get this error message: "Please manually reset the Open Therm Gateway"

What can I do to fix this? Like asked for help.
User avatar
sj3fk3
Member
Member
Posts: 119
Joined: Mon Apr 23, 2012 8:33 am
Location: Abcoude

Re: Flashing firmware problem

Post by sj3fk3 »

Chriskras wrote:This week I got a GatewayOT inside.
This I now flash the correct firmware. I want it gateway.hex flash but I get this error message: "Please manually reset the Open Therm Gateway"
What can I do to fix this? Like asked for help.
Did you try powering off and on the OTGW at that moment? Because it's not really an error but a command (for the user). You need to power cycle the OTGW for the upload to start.
Kind Regards,
Greg.
Chriskras
Starting Member
Starting Member
Posts: 17
Joined: Thu Nov 14, 2013 12:36 pm

Re: Flashing firmware problem

Post by Chriskras »

Solved my problem was that all of the RS232 connectors were not connected. So here I soldered it again.
Post Reply

Return to “Opentherm Gateway Forum”