Dimmer with 24v led

Forum all about Z-Wave Fibaro
Post Reply
geritz81
Starting Member
Starting Member
Posts: 6
Joined: Fri Aug 07, 2015 8:41 am

Dimmer with 24v led

Post by geritz81 »

I am trying to install a dimmer 2 in a wall box where a led lamp is plugged in. (I am aware of the risks when plugging in other devices then the acutal lamp :-) )
This lamp has 48leds on the adapter the output voltage is 24V.
After instelling this dimmer and plugging in the lamp the auto calibration starts, but ends up in a red led.
The lamp itself is on but on a very low strenght. No response on increasing the dimming percentage, nor switching on or off.

When I plug-in another lamp it works perfectly, so installation should be ok.

The manual hints about low power consumption in case when red led is ulluminated.
Do I need to install a bypass or do I need to adjust any parameters ?
Post Reply

Return to “Fibaro”