Harmony 1000 programming

Post by **DennisH** » Sat Oct 24, 2009 9:03 am

Hello,
Can someone tell me how to setup the Harmony 1000 to be used with Xanura?
I have a IRIX35 installed in the P-serie and i have already installed Xanura on the Harmony 1000.
Regards,
Dennis

Post by **TANE** » Sat Oct 24, 2009 9:42 pm

What is the problem?
If all is installed just send the correct IR signal for triggering.

Example A1 on

<hr noshade size="1">Enver
http://twitter.com/Chak64%20My%20Domoti ... dware.html My Domotica Hardware Software

Post by **DennisH** » Sat Oct 24, 2009 10:22 pm

That is the problem!
Where in the logitech software can i program this?
Regards
Dennis

Post by **TANE** » Sat Oct 24, 2009 10:38 pm

Which remote did you selected for x10 control in the Harmony Software.

<hr noshade size="1">Enver
http://twitter.com/Chak64%20My%20Domoti ... dware.html My Domotica Hardware Software

Post by **DennisH** » Sun Oct 25, 2009 3:29 pm

Which remote would you recommend tot program into the Harmony?
Regards,
Dennis

Post by **Bwired** » Sun Oct 25, 2009 4:37 pm

this is going good

<hr noshade size="1">Pieter Knuvers
http://www.bwired.nl Online House in the netherlands. Domotica, Home Automation.

Post by **DennisH** » Sun Oct 25, 2009 5:08 pm

I've had Eaton Xanura selected.
I now have tried several different options but i can't find the option that Light 1 is A1
Regards,
Dennis