2nd RFXMeter not working?

[Tozz]

I just received my second RFXMeter, plugged it in.. wanted to add new device in HomeSeer... Nothing HomeSeer doesnt seem to 'hear' the additional RFXMeter. I've read in the RFXPulse manual that by default all units are shipped with the same address. Is that also true for RFXMeter?

I tried to change the address but this didn't work out:
- Disconnect power for 10s
- Hold button
- Restore power
- Release hold button until green light turns on

When I do this the green light goes off after I release the button. If I read the manual correct it should remain lit.

Any ideas?

[Tozz]

Alright. Fixed it 2nd RFXMeter has indeed the same address as my first unit, so the address needs to be adjusted. I didn't get from reading the manual that it helpt you through its 'setup menu' using RFreceiver. I thought it was done 'reading' the LED status. I changed the module address.