Define address of Micro Modules

Forum about Xanura, Eaton Holec and Marmitek and other brand X10 and A10 devices.
Post Reply
backkri
Starting Member
Starting Member
Posts: 3
Joined: Sun Dec 30, 2012 4:16 pm

Define address of Micro Modules

Post by backkri »

Hi all,

Something I always struggle with, is the definition of the address of Micro modules, in this case a S3160M that has lost it's address because a power dip (but also applicable for other modules). What is the correct procedure?

The manual says: press the setup button for 5 seconds (so far so good) and then 'send the adress'. I use my CM15pro or remote control to send an 'ON' command, but module simply jumps out of setup mode after 30 seconds. I tried other commands, but no luck. In the past I succeeded in programming the modules (but it never seems to work at the first try), but now I don't arrive at all.

Regards,

Kristof.
Active Home Pro + CM15pro + Easytouch 35
Post Reply

Return to “X10, A10 Xanura Marmitek Forum”