Controller positon on wire

Forum about 1-Wire devices.
Post Reply
AshaiRey
Senior Member
Senior Member
Posts: 1310
Joined: Mon Feb 02, 2009 5:27 pm
Location: Netherlands
Contact:

Controller positon on wire

Post by AshaiRey »

Is it possible to put te controller in the middle of the wire or must it be at one end of the wire?
Let me explain this.
I have to position the controller near a 220V junctionbox. From there i need to run a wire of about 5 meter in one direction and 4 meter into the opposite direction.
Bram
123unlock
Member
Member
Posts: 86
Joined: Sun Jun 03, 2012 3:08 pm
Location: Apeldoorn / Netherlands
Contact:

Re: Controller positon on wire

Post by 123unlock »

Hi Bram,

Yes this is possible, make sure the data and gnd are correctly positioned. then it should not matter on what location the controller is.
here i had the same situation, but the controller is the middle works perfect, at least for the DS18Sxx temp sensors
Xtrusion Digital Home Automation Project
AshaiRey
Senior Member
Senior Member
Posts: 1310
Joined: Mon Feb 02, 2009 5:27 pm
Location: Netherlands
Contact:

Re: Controller positon on wire

Post by AshaiRey »

Thx for this information
Bram
vincenttor
Member
Member
Posts: 344
Joined: Thu Jan 09, 2014 10:45 pm
Location: Netherlands

Re: Controller positon on wire

Post by vincenttor »

maybe interesting to read:

http://www.jon00.me.uk/onewireintro.shtml

I used a daisy chain connection also and some resistors to prevent errors,got about 9 sensors connected at my partents house with 1-wire and a arduino
Post Reply

Return to “1-Wire Forum”